Single Rebar - End Conditions tab
Used to add end conditions to either or both ends of the rebar.
Note: Use the EC Reduction to align the end condition with the end of the line you used to place the bar. Uncheck to draw the end condition at the end of the line you used to place the bar; this extends the end condition beyond the placement line.
The following descriptions apply to all start and end options.
Select the type of end condition for each position:
|Edit End Condition Values||When you select an end condition type, the standard values and angle are applied. If necessary, click Edit End Condition Values to enter custom end condition settings. See Rebar End Properties dialog.|
|Offset (Extension)||(Where Applicable) Positive (extends the bar) or negative (shortens the bar) the specified distance from the edge of the concrete element.|
|Rotation||Type a rotation angle (in degrees). Click to rotate the bar by increments of 90 degrees.|
Tip: For additional details, Working With End Conditions.