|Near/Far Lap Splice Preferences
Stock – Sets the percentage to use laps at the maximum bar length.
Type a percentage in the
% Over field to allow this amount over
the maximum length.
Length – When checked, makes the bar lengths along all equal.
Laps– Staggers the bar laps by the indicated distance set in the
||Settings available to both Near and Far laps, each
in Horizontal / Vertical direction.
Method – Sets the method for the lap, selected one from the three
Bar Diameter, and
Length / Multiplier
Length is selected as the Lap Method , this
value set in the adjacent field will be used for bar laps.
Bar Diameter is selected as the Lap Method,
then type the diameter multiplier to use and the calculated lap length is shown
It is disabled for
Mechanical Device method.
Length – Type the bar stock length for the bar size used (default
Length – Type the manufactured length for the bar size used
(default is 60'-0").