To Snap a Tentative Point to an Element When More than One Element Lies at the Desired Snap Point
-
Enable snapping.
- Position the pointer on or near the desired point.
-
Press the Tentative button.
Of the elements at the desired snap point, a tentative point will snap to the element that was placed in the design earliest. That element is highlighted.
- (Optional)
If the desired element was not snapped to (highlighted), press the Tentative button again.
Of the remaining elements at the desired snap point (the ones to which a tentative point has not snapped), a tentative point snaps to the element that was placed in the design earliest. That element is highlighted.
- (Optional) Repeat step 4 until the desired element is highlighted.
