MicroStation CONNECT Edition Help

Edit Multi-line Cap

Used to change the end cap of a multi-line.

You can access this tool from the following:
  • Ribbon: Drawing > Home > Multi-lines
  • Toolbox: Multi-lines

Cap Mode Sets type of end cap:
  • None — Removes any end caps. The end cap angle will be 90°. Effect is same as Cut All Component Lines tool.
  • Current — Does not change the end cap. Enabled only when Adjust Angle is turned on.
  • Active — Uses the active multi-line definition for the end cap.
  • Joint — Uses the multi-line's joint definition instead of its cap definitions. Ensures end cap will always be 90°.
Adjust Angle If on, lets you adjust the angle of the end cap.
Tip: Using AccuDraw with the Adjust Angle option makes it easier to make the end cap perpendicular to the rest of the multi-line.