Placing a Selection Segment within a Direction Modifier
If your Direction Modifier affects a percentage of Entities, rather than all of them, you may like to specify which Entities within this percentage are affected first. You can do this by placing a ‘Selection Segment’ within the Direction Modifier.
Those Entities closest to the segment will be affected first (for example, a percentage of those Entities near a segment placed along the edge of a platform would be the first to board an arriving train). A Direction Modifier can only contain one Selection Segment.
To place a Selection Segment:
- Select the Direction Modifier.
-
Right-click within the area of the Direction Modifier at the point
you would like to place the segment and select
Add Selection Segment.
A very short segment is placed at this point, indicated by a cyan square.
- To lengthen the segment, click on the square and drag the segment to the desired length. Click again to place the segment.
- To reposition the segment, click on its vertices and drag to the position you require.
- To remove a segment, select the Direction Modifier, right-click within it and select Delete Selection Segment.