Fit Plane tool settings
Setting | Description |
---|---|
Slab\Prism |
Specifies the selection method to be used in the draping operation. |
Thickness |
Defines the thickness of the selection volume (Slab or Prism). Tip: dynamically measure on the point cloud to set this parameter by clicking on the icon. |
Extend Output |
Extend the geometry computed by the specified scale factor. Tip: extending planes may simplify the further adjustment of connected planes using Trim Surface tool. |
Horizontal\Vertical |
Constrain the output to be either Vertical or Horizontal if the deviation is within a tolerance. The tolerance is an angular value in degrees defining the maximum deviation of the plane to consider the Horizontal\Vertical constraint. |
Use ACS |
Use the ACS direction as the main direction to constrain the normal. |
Use All Point Clouds |
Use all attached point clouds during processing. |