Editing transit line routes
To edit a transit line’s route:
- Click on the line you want to edit to enable Edit mode (line highlighted in green)
- Right-click on one of the
line’s nodes to toggle the Transit Line Editor wheel.
- Right-click on the
appropriate node :
- The anchor node will be highlighted in red
- The anchor serves as the fixed point from which changes/rerouting originate. When a line is first selected the anchor point is by default set to be the line’s start node.
- To Clear the anchor:
Multiple route edits can be done from this point:
- Set the current line’s end node to be the Anchor.
- Click on the node you want to extend the line to (new end node).
- Right-click
to save the changes:
- Set the anchor to be the rerouting starting point.
- Right-click on the anchor
node again
- Click on either:
- Right-click to save the changes
- Set the anchor to be the starting point of the direct link
- CTRL+Click to the end node where you want the direct link to go to.
- Right-click to save the changes
- Open the Transit Line Layers Properties:
- Open the Data Source tab
- Write the corresponding cost function in the Cost function code block.
- Click Apply
- Duplicating a
line:
To create a copy of a line and its attributes:
• Right-click on any of the line nodes
:
• Click on the Create Transit Line drop-down
in the GIS Editor toolbar: Flipping a line's direction:
The direction of a line is determined in the sequence_number field in the Transit Network Sequence tab in the Feature table. It is possible to change the direction of the line:
• Right-click on any of the line
nodes
• Click on the Transit Line drop-down in the toolbar
- . Right-click on the node you want to set to a stop/non-stop node.
- . Click on Stop to toggle
between setting the node to Stop and Non-stop:
You can also modify stop/non-stop nodes from the Feature Table by:
• Typing the corresponding value for stop/non-stop (1 or 0)
in the stop field