Enabled?
|
Toggle the overrides on or
off by checking or unchecking the box.
|
Controlled Element
|
The element to which the
overrides applies.
|
Element Type
|
The type of element to which
the override applies.
|
Attribute
|
Based on the element type
certain attributed are editable:
-
- Pump,
Variable Speed Pump Battery
- Pump
Status - Sets whether the pump is on or off.
- Pump
Setting - Applies a multiplier to the flow in the pump curve.
- Conduit
- Pipe
Status - Sets whether the pipe is open or closed.
- Orifice
Setting - if the conduit has a start orifice structure can set a fraction
multiplier to the orifice area, where Fully Open = 1.0 and Closed = 0.0
- Weir
Setting - if the conduit has a start weir structure can set a fraction
multiplier to the freeboard height of the weir. Where Fully Open = 1.0 and
Closed = 0.0
- Outlet
Setting - if the conduit has a start generic outlet control can set a
multiplier to defined outflow.
-
- Pressure
Pipe
- Pipe
Status - Sets whether the pipe is open or closed.
|
Value
|
Based on the Attribute, enter
the override value.
|
Start Date
|
Specify the Start Date when
the override becomes enabled.
|
Start Time
|
Specify the Start Time on
the Start Date when the override becomes enabled.
|
Duration
|
Specify the amount of time
that the override is in effect. If the value is 0 will assume to run the
override for the entire simulation.
|
Priority
|
Specify the priority of the
override. The higher priority value wins, in the case of contradictory override
controls.
|
Notes
|
Any notes to associate with
current override.
|