-
「ブリッジデッキ」リボンタブで、「荷重」グループのツールの順に選択します。
「荷重作成パラメータ」ダイアログが開きます。
-
On the General tab, Select BS5400 Part 2 as the Design Code.
The <code> tab updates to BS5400.
-
Select Ultimate for the Limit State.
-
Select the BS5400 tab.
Note: For this example, the default single load case with the nominal HB vehicle and unit of 30 are OK.
-
Select the Node Displacements tab.
Note: An action must be defined for which the maximum results determine the placement of the moving loads. This example will use the same action as reviewed above in the influence surface.
-
Enter the following data into the Node Displacements table:
Node |
Displacement |
Effect |
104 |
Y |
+ve |
104 |
Y |
-ve |
-
「OK」をクリックします。
デッキが解析されて、設定された動作に対する限界荷重の位置が得られます。
デフォルトのテキストエディタ(たとえば、ノートパッド)に解析の要約が開きます。ファイル(
ファイル名_deckx.outという名称)が、入力ファイルと同じ場所に保存されます。このファイルを確認したら、テキストエディタを閉じます。