Add
On-Grid |
Opens the Add <material> On-Grid
Mode dialog, which is used to add beams using the
current Grid Lines and columns for beam end points. |
Add Off-Grid |
Opens the Add <material> Off-Grid
Mode dialog, which is used to add a single beam using
existing beams or columns as reference points. |
Add
Generation |
Opens the Add <material> Generation
Mode dialog, which is used to add multiple beams by
using an existing line of beams as a reference. |
Add Pan Joist/Beam |
(Concrete only) Opens the Add Concrete Pan
Joist/Beam Generation Mode dialog, which is used to
add multiple concrete beams using pan forms. |
Assign Cantilevers |
Opens the Assign Cantilever Beam
Mode dialog, which is used to add a cantilevered end
to an existing beam. |
Move |
Opens the Move Beam dialog,
which is used to move beams. |
Offset |
Opens the Offset Beam dialog,
which is used to offset beams. |
Assign Rigid Links |
Opens the Assign Beam Rigid
Links dialog, which is used to add or delete beam
rigid links. |
Delete |
Opens the <material> Beam
Delete dialog, which is used to delete beams.
|
Delete Cantilevers |
Opens the <material> Cantilever
Delete dialog, which is used to delete beam
cantilevers. |
Change Properties |
Opens the Change <material> Beam
Properties Mode dialog, which is used to change beam
properties. |
Change Materials |
Opens the Change <material> Beam
Material Mode dialog, which is used to change the
material of an existing beam.. |
Show |
Prompts you to select a beam and then opens the
Beam Show Mode dialog, which is used to
show the properties and location of a beam. |
Size Restriction |
(Steel, Steel Joist, and C-Beam only) Opens the <material> Beam Size
Restriction Mode dialog, which is used to impose a
depth restriction for the beam optimization on one or more beams. |
Steel Table |
(Steel, Steel Joist, and C-Beam only) Opens the Beam <material> Table
Selection dialog, which is used to assign the default
or alternate steel table to one or more beams. |
LL Reduction |
Opens the <material> Live Load
Reduction dialog, which is used to assign a maximum
live load reduction factor percentage to one or more beams. |
Stub Cantilever Slope |
Opens the Modify Stub Cantilever
Slope dialog, which is used to modify the slope of
stub cantilevers. |
Web Openings > |
Add |
(Steel Only) Opens the Web Openings Layout
Mode dialog, which is used to add web openings in
steel beams. |
Change |
(Steel Only) Opens the Change Openings
Layout Mode dialog, which is used to modify web
openings in steel beams. |
Delete |
(Steel Only) Opens the Web Openings Delete
Mode dialog, which is used to remove web openings in
steel beams. |
Show |
Prompts you to select a beam and then opens the
Web Opening Show Mode dialog, which is used
to show the location and dimensions of a web opening. |
Brace Points |
Opens the User Brace Point Layout
Mode dialog, which is used to define brace points
along the top and/or bottom flange of a beam. |
Assign Beam Fixity |
Opens the Assign Beam Fixity
dialog, which is used to assign end fixity conditions to beams. |
Assign Duct Size |
(C-Beam only) Opens the
Assign Duct Size dialog, which is used to
specify the size of duct that must pass through the opening of a C-Beam. |
Assign Beam Size |
Opens the Assign <material> Size
Mode dialog, which is used to assign a size to one or
more beams. |
Clear Beam Size |
Opens the Clear <material> Beam
Size dialog, which is used to clear user assigned
sizes and stud configurations that were assigned either in RAM Manager or RAM Steel Beam. |